You will need the P9288 firmware update tool installed on a Windows PC.
This tool can be downloaded from the website.

https://www.fastmateracing.com/p9288-system-tester/

Familiarise yourself with the steps below before doing anything. Commonly you just 
need to do the App update and leave the USB side until a newer version is released.

The current version numbers of the USB code and App loaded on the tester are shown 
on the display when plugged in via USB. 

App installation:
Plug the tester in to the PC via USB lead. The cable must support charge and data.
When the P9288 drive pops up you can use Load package to update the App using the bin 
file e.g. P9288_v3.23_package.bin (English version)
Other language selections include Danish, German, Spanish, Finnish, French, Italian
Dutch and Swedish. These are only available for the App and denoted by suffix
e.g. P9288_v3.23_package-DE.bin (German version)

Progress is shown in the updater and on the tester display. Wait a few seconds until the 
update is complete and the new version number is shown on the tester screen.

USB update:

It is worth updating if the USB version is older than the latest on the website. 
If no USB version number is shown then you should definitely update to the latest.

Use the updater to load the latest USB version e.g. 9288reboot104.bin and then plug 
the tester into the car. The screen will show progress and you can disconnect when 
OLED shows 'Boot updated OK'

The tester App must be re-installed after updating the USB code so follow the steps
for App installation above.


