After updating firmware you get SENSOR ERROR
You have only updated the firmware, you need to update the bootloader too. Start again and make sure to do both steps on the downloads page.
If your gauge won’t turn on – Hardware reset
1, Large RaceSense Tyre Gauges purchased after summer 24 have a hardware reset built in- these have a built in beeper. Hold the Select (bottom button) for 10 seconds and the gauge will power off. It can then be turned on by pressing ON as usual.
Pocket gauges that have the yellow OLED surround (since July 25) have this too.
2, If you still have no display or your gauge doesn’t have the reset. Plug into a computer for an hour, if you get the RaceSense folder pop up the update the firmware instructions here
If you still need help please email us at hello@fastmateracing.com
Gauge stays in USB mode when unplugged
1, Plugging and unplugging into a PC will take it out of this mode. Or if you can do a hardware reset (hold the Select button for 10 secs) (needs v1.35 rebooter installed).
If you’ve seen this we recommend updating the firmware and rebooter to the latest versions on Tyre Gauge Downloads
Battery charging recommendation
We recommend using the gauges until the battery indicator is low and then to charge for an hour
(Pocket) or two (RaceSense Tyre Gauge) at room temperature. This will maximise the useful life of the battery.
The battery indicator on the gauges shows battery voltage and not capacity. It is normal for the voltage to drop after charging is complete.
There is no need to fully charge all the time and keeping the gauge topped up will reduce battery capacity. Do not leave them charging overnight or longer.
How long does the battery last?
The battery capacity of both gauges is very large compared to their power consumption. The Pocket gauge can in theory operate for over 8 hours continuously once charged. A typical set of measurements takes around 1min including temperatures and a bit of time to adjust pressures. So, 8 hours of operation is about 500 complete sets of measurements without stopping! If only pressures are recorded that number will be over 1000.
The standard gauge has similar power consumption but the battery has double the capacity. So, once charged either gauge should easily last a weekend with very heavy use.
More battery charging details
The typical time to fully charge a standard gauge from completely discharged is 2 to 3 hours and 1 to 2 hours for a Pocket. Longer periods of charging will reduce the battery life. So, gauges should not be left charging overnight or unattended.
The bulk of the battery charge is completed in about an hour of charging e.g. the Pocket from empty will be over two-thirds full within an hour. The remaining charge takes longer to complete.
Charging is automatically disabled when the battery is full. At this point the gauge stops taking power from USB and will be powered from the battery. After a while the battery voltage drops enough that charging starts again. This means that leaving a gauge charging for long periods does not guarantee a fully charged gauge and repeated operation like this reduces battery life.
Gauges should not be charged when unusually hot or cold. For example, if they are left in the sun or outside in freezing temperatures the gauge should first be allowed to reach room temperature around 20 C (68 F) before charging. Charging is automatically disabled below 0 C (32 F) and above 40 C (104 F) but charging near these limits will reduce the battery life.