Diagnostics for Porsche 928, 944, 968 and 911 (964 & 933)

Porsche models from the late 1980s to the mid 1990s use a proprietary version of the KWP1281 K & L-line protocol. Modern OBD2 tools show nothing useful on these cars.

The factory tool – and until now the best tool – was the Bosch KTS300, the “Hammer”, with its plug-in KTS301 Porsche module. Those are over thirty years old now and rare. A full set is bulky and expensive and often need repair. A Hammer scan takes over a minute and just shows progress bar. Once scanned the Hammer only shows one item per screen.

The P9288 is a modern replacement designed and assembled in the UK. It scans in less than half the time, and names each control unit on screen as it is found, so you can easily see progress. Single units can be selected even quicker, and several readings shown at once on the large display.

DIAGNOSTIC FUNCTIONS

▪  Read faults – decoded to plain text, not raw codes

▪  Clear faults

▪  Set actuators – switch items to check operation e.g. central locking, blowers, heater flaps, engine valves. Normally engine stopped.

▪  Input signals – read switch states: idle, WOTS, doors and more

▪  Actual values – live voltages, temperatures and RPM with the engine running

▪  Where the ECU supports it – active drive links with the engine running, CO adjustment, read coding, idle adaptation, knock detection etc.

▪  International –As well as English the unit supports Danish, German, Spanish, Finnish, French, Italian, Dutch and Swedish language versions

Available functions vary by control unit and version. Some ECUs offer faults and/or actual values only.

P9288vHammer

P9288 System Tester – £495

Download Installer

Firmware (Download and unzip the package. Instructions are in the Installation.txt in the firmware file.)

Download latest firmware

Download latest USB

Change Log

v3.24:
Fixes communication error reading faults on 928 PSD
v3.23 adds:
Adaptation values for 944, 964 and 968 which are hidden on Hammer
Complete support for fault reporting on M05 and M07 version now complete.
Temperature can be configured in settings to Celsius or Fahrenheit
v3.06 fixes temp range for adaption and enhances data logging
v1.03 USB code supports the new data logging
v2.67 fixes occasional connection failures due to exiting part way through scan and then quickly reconnecting. Blink codes are now shown on their own screen as a list from Settings menu.
The app version number is now visible from USB when v1.01 of USB code is programmed.

V2.49 software now has working 928 LH actuators menu

V247 This version supports all versions of the 928 LH, fixes some issues with 928 adaptation and reads blink codes.